DIN 3906 pdf standards

Jun 06, 2019

DIN 3906 is for Non soldering compression fittings with cutting ring - Branch T-stud with taper threaded stud end (not for new design).

This standard is included in DIN Handbook 348. Applies to taper stud tees (stud branch) (hereinafter briefly referred to as tees) with bore Type W in accordance with DIN 3861, which are used for solderless pipe joint assemblies.

Standards references as follow:

ISO 8434-1 : 2007 METALLIC TUBE CONNECTIONS FOR FLUID POWER AND GENERAL USE - PART 1: 24 DEGREE CONE CONNECTORS

ISO 4042 : 1999 FASTENERS - ELECTROPLATED COATINGS

EN ISO 4042 : 1999 FASTENERS - ELECTROPLATED COATINGS (ISO 4042:1999)

DIN 3859-1 : 2005 COMPRESSION COUPLINGS - PART 1: TECHNICAL DELIVERY CONDITIONS

DIN 158-1 : 1997 METRIC EXTERNAL TAPER SCREW THREADS AND MATING INTERNAL PARALLEL SCREW THREADS - PART 1: NOMINAL SIZES, LIMIT DEVIATIONS, LIMITS OF SIZE AND VERIFICATION

DIN 3852-1 : 2014 STUD ENDS AND PORTS OF FITTINGS, VALVES AND PLUG SCREWS - PART 1: DIMENSIONS FOR METRIC FINE PITCH THREAD

DIN 3853 : 2001 NON-SOLDERING AND SOLDERING COMPRESSION FITTINGS - STUD ENDS FOR USE WITH UNION NUT; DESIGN SHEET

EN ISO 8434-1 : 2007 COR 2009 METALLIC TUBE CONNECTIONS FOR FLUID POWER AND GENERAL USE - PART 1: 24 DEGREE CONE CONNECTORS

DIN EN ISO 4042 : 2001 FASTENERS - ELECTROPLATED COATINGS

DIN 3943 : 2002 NON-SOLDERED COMPRESSION FITTINGS - SWIVEL BRANCH TEES WITH 24 DEGREE CONE CONNECTORS WITH O-RING - ADJUSTABLE, FOR DESIGN AND TYPE OF COMPRESSION END ACCORDING TO DIN EN ISO 8434-1

DIN EN ISO 8434-1 : 2016 METALLIC TUBE CONNECTIONS FOR FLUID POWER AND GENERAL USE - PART 1: 24 DEGREE CONE CONNECTORS

DIN 3852-2 : 2014 STUD ENDS AND PORTS OF FITTINGS, VALVES AND PLUG SCREWS - PART 2: DIMENSIONS FOR PIPE THREAD